A-1001 Documentation

Read Before Operation to Avoid Damage to Unit!

The A-1001 is a self-contained electronic flare that is buoyant. The Mini Solo unit is mountable to any standard 1/4-20 universal thread. The Mini Solo is also USCG Approved for carriage under 33 CFR 175.105.

1. Registration & Initial Setup

  • Register Device: Please visit Siriussignal.com to register your device. Note that registration is not required for immediate use.
  • Training: It is highly recommended to view the instructional video on the website before installing batteries.

2. Operating Instructions

  • To Turn On: Hold the device body in one hand and turn the optical lens assembly clockwise until the light activates.
  • Deployment: When the signal is active, display the light above the line of sight for maximum visibility.
  • To Turn Off: Turn the lens optic cover counter-clockwise. Once the light is off, continue to turn it approximately one full turn to prevent accidental activation.

3. Battery Installation & Replacement

The A-1001 requires three (3) CR123 batteries.

  1. Unscrew the module assembly completely by turning it counter-clockwise and remove the battery holder.
  2. Install the batteries according to the polarity markings (+/-) in the holder.
  3. Critical Step: Reinstall the battery holder with the side marked “TOP” facing up. Incorrect installation will damage the device.
  4. Secure the module by tightening the optical lens assembly clockwise until the light turns on to confirm a successful connection.

4. Daytime Distress Flag

To access the daytime distress flag, twist the red end cap counter-clockwise to remove it from the device.

WARNING: EMERGENCY USE ONLY

  • Do not look directly at the light; it is extremely bright.
  • This device contains an infrared LED emitting invisible light.
Register Your Device
Shop All Products